Replaced Maf Sensor Check Engine Still On
Replaced Maf Sensor Check Engine Still On. I did notice a sucking noise while the hood was up and the engine was running. After about a week, the engine light is back on and fuel efficiently is noticeably impacted.
I also changed the connector for the mass air flow sensor. I could not believe how much torquei got by replacing this sensor. One of the most common causes of check engine popping up after maf sensor replacement is having a faulty replacement.
This Time I Get A Replacement Maf, A New Air Filter, And A New Battery= The Car Maybe Made It.
Check engine still on after replacing map sensor code p0106. I believe there is a tsb to have ecu rebooted. I did notice a sucking noise while the hood was up and the engine was running.
The Oxygen Sensor Was Replaced, 'Check Engine' Light Is Still On.
When did you first notice it? Just replaced maf sensor because it had rough idle and poor acceleration. I might buy one for myself.
The Entire System Can Be Reset By Unhooking The Battery And Leaving It Unhooked For 10 Minutes.
Even with the check engine light off, you could have a. I cleaned the maf sensor, replaced the air filter and have not reset the computer yet. By tarekaziz » mon apr 24, 2017 11:05 am.
Replaced Maf, Check Engine Light On.
Maf replaced, but check engine light still on! I also changed the connector for the mass air flow sensor. Replace maf, trans oil changed at 65000, crank shaft sensor replaced, brakes replaced at 75000, rear speed sensor replaced, power steering leak fixed, dvd gps and antenna installed, towing package installed, still light motor oil leak.
Key On Engine Off It Should Be Approximately 4.5 Volts, Idling In The 1 Volt Range And Go Over 4 Volts At A Snap Throttle.
Reset code and drive vehicle. The car doctor responds john paul 1/25/2022. 1) disconnect the negative connection of the battery.
Post a Comment for "Replaced Maf Sensor Check Engine Still On"