Hunter Rain Sensor Installation
Hunter Rain Sensor Installation. Connect one wire from the sensor to one wire terminal labeled sen, then connect the other sensor wire to the other wire terminal labeled sen.(figure 2) other controllers Connect one wire to the rs terminal and other to the c terminal.
This allows you to easily override the sensor by using the run (bypass sensor) position on the dial. Attach yellow wires to 24vac and com terminals. Connect one wire from the sensor to one wire terminal labeled sen, then connect the other sensor wire to the other wire terminal labeled sen.(figure 2) other controllers
Remove The Jumper From The Two “Sen” Terminals.
How to install a wireless rain/freeze sensor to a hunter irrigation timer and how it operates. So, make sure to go through the owner’s manual to further isolate the problem. Click here for help configuring a sensor.
Connect The Blue And White Wire To Any Of The Four Sensor Terminal Pairs (Sen 1 Shown).
Connect one wire to the terminal labeled “sen” and the other wire to the other “sen” terminal (see figure 2). Install the sgm on the sensor by removing the extension arm supplied with your sensor and reinstalling sgm in its place. See acc owner’s manual for further details.
Passive Rain Sensors Can Be Installed Using The “S1 Or S2” Input Terminals And The “C” Terminal Located Below The S2 Terminal.
Connect one wire from the sensor to one wire terminal labeled sen, then connect the other sensor wire to the other wire terminal labeled sen.(figure 2) other controllers Powered rain sensors can have power supplied by the 24 vac and common terminal below the s2 terminal on the spruce controller. I think the battery on the sensor is going.
This Allows The Timer To Advance As Scheduled, But Keeps The Valves From Opening The Water Flow.
Use features at the “set sensor operation” dial position on acc to complete setup. Configure in the hydrawise app. Connect one wire to the rs terminal and other to the c terminal (see figure 1).
Connect The Blue And White Wire To Any Of The Four Sensor Terminal Pairs (Sen 1 Shown).
Sensor is bypassed rain sensor bypass wiring the receiver to a hunter acc 1. The sensor gutter mount (sgm) allows the sensor to be mounted directly to the edge of a gutter. First, the wiring diagram offered by rachio for connecting the hunter rain clik sensor to the rachio 3 is correct.
Post a Comment for "Hunter Rain Sensor Installation"