Road Glide Engine Temp Sensor
Road Glide Engine Temp Sensor. Engine temperature sensor by smp®. #5 · apr 29, 2013.
Part h210170 fits the following machines. As low as 0% apr for 12 months with. The list of these parts includes mass airflow, coolant volume and temperature, cam and crank, cylinder head temp, and several other sensors.
The Thing Looked Brand New But Who Knows.
A harley davidson motorcycle is a great machine for riding on all kinds of roads. Common symptoms of a failing manifold absolute pressure sensor (map) include rough idle, poor gas mileage, hard starts, stalling, or a check engine light (trouble code recorded). The sensor is located on the left side of the bike toward the rear of the front head (hope that makes sense).
On The Oil Pan, Just To The Right Of The Engine Oil Drain Plug Is Another Plug, Remove That And Place In The The One From The Kit With The Temp Sensor.
Mass airflow sensors are specifically designed to provide the electronic engine management system with the necessary information about the volume of air taken in for further mixing with gasoline before it can be compressed and ignited. There were problems with the cooling system. The sensor is known to fail and usually a rich fuel condition (black smoke).
The Other Day I Went Over Just About Everything On My Bike And Pulled The Boot Off The Head Temp Sensor To Make Sure It Was Still Tightend In There.
Check your service manual or verify with a trained technician to further diagnose and determine the cause of such problems.* Fans and pump are coming on under diagnostics. I went to the local hd dealer and got a new sensor for around $40.
I Notice That The Ecu Reports The Temperature About 18F Colder Than What My Sensor Measures.
I can't not imagine that replacing a failed temp sensor would make a negative impact on the way the bike runs unless some sort of adjustment was made beforehand to compensate for the failed sensor. Namz® delphi series oem intake air temperature sensor connector. Discussion starter · #4 · dec 12, 2016 (edited) thanks guys, i'm throwing a p1019 code.
These Components Are Engineered To Measure The Air Intake Temperature And Its Volume And.
Temp sensor is located on front cylinder in an opening in the center of the valve cover, follow the wires and you will find it. Give the engine some throttle and as soon as the engine rpms hits 1200, the ecu goes back to closed loop mode at 14.7:1 which is too lean, it drives engine temperature even higher and the. Et sensor ,as glider said it is a single sensor located on your front cylinder head,the sensor provides input signals to the ecm as it reacts to the tempeture of the front cylinder head, the ecm uses this signals from the sensor to determine if the engine is at operating tempeture or warming up from cold start.
Post a Comment for "Road Glide Engine Temp Sensor"