Disconnect O2 Sensor Connector
Disconnect O2 Sensor Connector. In this case i think it was difficult because there was a lot of grime on the surface of the plug where it was inserted into the connector. Ls6 lt1 corvette flat 24.
Jumper harness ckt 412 to ground. The metal holder is bolted to the top of the transmission. You may have more than one.
Do Not Attempt To Repair The Wiring, Connector Or Terminals.do Not Solder The Connectors Onto The Wires.do Not Throw Water On The O2 Sensor As This Can Crack The Exhaust Manifold Or Exhaust System When It Is Cooled Too Fast.
Be design it won't hurt anything, but you could run so rich that you wash down the cylinder walls and score the heck out of them which means its rebuild time. Then reached in with long needle nose pliers and squeezed the tab so o2 connector could be removed from metal holder. All you need is a wrench for this replacement job.
Ls1 Ls6 Lt1 Corvette Oxygen O2 Sensor Header Extension 4 Pin Flat 24.
To disconnect the two halves, squeeze the prong. Do not touch the sensor or the heat shield until the engine cools down. It's a connector, not a head bolt.
Ls1 Ls6 Lt1 Corvette Oxygen O2 Sensor Header Extension Harness 4 Pin Flat 36.
Besides, don’t forget to use proper hand gloves. Ls6 lt1 corvette flat 24. Trying to change the downstream o2 sensor.
Used Small Screw Driver To Unlock Tab On Connector.
Unplug the wire at the connector and remove o2 sensor. Check voltage of ckt 412 at o2 sensor harness connector using a digital voltmeter. Not sure what that means and if or even if it is.
Jumper Harness Ckt 412 To Ground.
It has a “grenade pin” that prevents the latch from releasing accidentally and is a pita to remove. Only disconnect if you really must. Carefully unplug the wiring attached to the sensor.
Post a Comment for "Disconnect O2 Sensor Connector"