Cartell Driveway Sensor Troubleshooting
Cartell Driveway Sensor Troubleshooting. For more information, see sell sheet. Not appropriate for solar gates.
Call cartell for further troubleshooting before digging up the system. At your system’s panel, place a resistor (if required) between the terminals in parallel (see system manual for correct resistor size). Buried in the middle of the driveway, this system covers a 24 foot wide driveway (see installing sensor probe and cable, below).
If The Signal From Sensor Puck Is Not Reaching The Integrator:
The false alarm may occur due to water entering the sensor because we changed our potting Call cartell for further troubleshooting before digging up the system. For more information, see sell sheet.
Our Systems Are Only Activated By Moving Steel.
So when you receive an alert, you can be sure it’s caused by a car entering or leaving your driveway. All driveway alarms can handle some amount of physical interference that occurs between your sensor and receiver. Move the sensor closer to the integrator, and/or 2.
Cartell.com To Our Cartell Family:
This is a nice feature. Cartell sensor probe with 100 ft. A direct burial cable is attached at the factory.
Installation Is Quick, Easy, And Versatile.
Use with all wired driveway alarm systems and pioneer free exit system Preferred technologies group manufacturer website address: For more information, see sell sheet.
Not Appropriate For Solar Gates.
Some of the zones they have are exterior flood lights and recessed lights. We have a customer who has a cartell driveway sensor installed at their house. Install sensor in the driveway, beside the driveway, or on a post adjacent to the drive.
Post a Comment for "Cartell Driveway Sensor Troubleshooting"