Throttle Position Sensor Relearn Procedure
Throttle Position Sensor Relearn Procedure. Turn the ignition switch on and wait 3 seconds. Steps on how to calibrate throttle position sensor idle air volume learning (throttle position learning) step 1;
7) if ckp sensor variation learn procedure was not terminated, go to next step. Accelerator pedal release position learning procedure. Make sure the accelerator pedal is fully released.
During That Period The Idle May Be Higher Idle Than Normal.
To do a mazda throttle body relearn procedure. Then tighten them down using a screwdriver. Make sure the accelerator pedal is fully released.
7) If Ckp Sensor Variation Learn Procedure Was Not Terminated, Go To Next Step.
Turn ignition switch “on” and wait at least 2 seconds. When the throttle plate is in the closed position, the tp sensor 1 signal voltage is near the low reference and increases as the throttle plate is opened. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds.
Once Ckp Sensor Variation Values Are Learned, The Pcm Will Return Engine Control To The Operator And Engine Will Respond To Throttle Position.
Begine to spray inside throttle body using little red hose that came with carb cleaner. Perform a hard pcm reset by disconnecting the battery cables from the battery and touching them together. Reinstall the connector the same way you removed it.
Restart The Engine And Check For Proper Idle Operation.
Make that the accelerator pedal is completely released or free, then turn “on” ignition switch and wait for 3 seconds. The idle may be unstable or a dtc may set if the throttle position is not learned. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.
Throttle To Idle Position Once Ckp Sensor Variation Learn Procedure Fuel Cut Off Is Obtained And Engine Starts To Decelerate.
Perform throttle valve closed position learning procedure. For example, to perform a throttle relearn on a 2008 silverado 5.3l, select and run the idle learn reset test. Do you know when to reprogram a throttle body?
Post a Comment for "Throttle Position Sensor Relearn Procedure"