Neptune Apex Optical Sensor Programming

Neptune Apex Optical Sensor Programming. Wirelessly update the ecotech driver with the firmware from step #3 5. I add an optical sensor to my existing apex based ato to act as my primary sensor.

Buy this Neptune Apex Optical Level Sensor (OS1) online from www.reefsupplies.ca

I add an optical sensor to my existing apex based ato to act as my primary sensor. I was just testing it. You really need to push them hard until they “click” into place.

Source: www.reefsupplies.ca

Ensure your optical sensor plugs are firmly seated in the fmm sockets. Go into the fmm module settings, click configure, then confirm outputs 1 and 2 are both detected as optical sensors.

Source: www.petpeoplesplace.com

At this point you are ready to program and use the vortech pump(s). All of this information is publicly available, but is scattered amongst several neptune documents and posts in the neptune community forums.

Source: www.reefsupplies.ca

Optical sensor this sensor plugs into your fmm and, using reflected infrared light, will signal your apex when it changes state from being wet to dry or dry to wet. I have 2 magnetic floats via the bob acting as high and low alarms as well.

Source: www.fish4kids.org

I add an optical sensor to my existing apex based ato to act as my primary sensor. Then its just on/off my neptune solenoid that's rodi bucket gravity fed into my sump looks like fallback off set off

Source: www.bulkreefsupply.com

The neptune optical sensor plugs directly into the fmm allowing you to monitor the level of your sump, mixing station, or any other reservoir with liquid in it. If needed, please upgrade the apex base unit firmware to 4.20_1b13 or higher before proceeding with the installation.

Source: www.reefsupplies.ca

A repeating on/off interval, where you specify the number of minutes & seconds to be on, and the number of minutes and seconds to be off Advanced leak detection module (ald).

At This Point You Are Ready To Program And Use The Vortech Pump(S).

Feel free to go back and read part 1, part 2, part 3, part 4, or part 5. I just hooked mine up and you need to switch the outlet between leak sensor and optical sensor. If swx4_1 open then on

“When” Offers The Software Equivalent Of A Backup Sensor And Can Be Programmed Into Any Outlet Controlled By Apex.

This command is used to react to either an optical sensor, leak sensor, or a switch connected to a breakout box port. With the various flow monitoring sensors you can monitor the flow inside the pipes of your return pump, emergency drains, reactor pumps, rodi feed, and much more. This command is used to react to either an optical sensor, leak sensor, or a switch connected to a breakout box port.

It Is Connected To My Fmm On My Apex.

You likely want your return pump, skimmer and power heads to turn off before the feeding begins. Neptune apex programming tutorials, part 6: Here is a picture of my diy neptune apex optical float switch.

Optical Sensor This Sensor Plugs Into Your Fmm And, Using Reflected Infrared Light, Will Signal Your Apex When It Changes State From Being Wet To Dry Or Dry To Wet.

Go into the fmm module settings, click configure, then confirm outlets 1 and 2 are both detected as optical sensors: You can continuously monitor the health of. All of this information is publicly available, but is scattered amongst several neptune documents and posts in the neptune community forums.

It Should Be Upside Down Or Sideways To Prevent Droplets From Accumulating On The Lens.

The current firmwa re version can be checked from the apex display on the self test screen. This article and several future ones by the same author were originally part of several presentations made to a local aquarium club on programming your neptune apex controller. Ensure your fmm module is correctly identifying the optical sensors.