Marine O2 Sensor Bung
Marine O2 Sensor Bung. This part will be fitted to hardin marine tailpipes. The other way to do it would be to weld the bung on both the inside and outside to seal it.
This is the water passage where the water that cools the exhaust travels. I stopped by bergeron on my way back to the lake and he said they have never found a good way to run o2 sensors in a marine exhaust. Stainless steel 18mm oxygen sensor plug this plug only is designed fit popular o2 bungs and ports designed to allow you to cap/plug a oxygen sensor bung price does not include bung only plug.
O2 Sensor Placement Is Critical For Getting Your Engine To Read The Oxygen In The Exhaust Correctly And Can Directly Impact The Performance Of Your New Efi Installation.
This part will be fitted to hardin marine tailpipes. O2 sensor bung and plug kit, stainless steel fittings, clear plastic case, exhaust safety, feuling parts, kit. These bungs are designed to allow you to weld in an oxygen sensor bung for convenient fuel injection or air fuel ratio calibration.
Fits Most Wideband & Narrow Band O2 Sensors.
This part will be fitted to hardin marine tailpipes. He also explains how to properly install them. Simply drill a hole in the exhaust, install the gasket, and bolt the clamp.
I Then Drilled The Passages That You Would See On The Innovate Extender Bung.
This passage must be sealed off so that no water gets into the tailpipe or onto the o2 sensor. He had one there that was ran on a dyno then the fuel map was set and shipped back. The o2 signal was slow and lazy, because it has no way to direct the exhaust flow up to the sensor.
O2 Sensor Weld Fittings Are The Ideal Way To Add A Sensor When Converting To Efi Or Adding A Wideband Air/Fuel Gauge For Tuning Carbureted Engines.
An o2 sensor is used when converting an engine to fuel injection and wanting to move from an “open loop” system to a “closed loop” system. Vibrant o2 oxygen sensor bung. This is the water passage where the water that cools the exhaust travels.
This Part Will Be Fitted To Hardin Marine Tailpipes.
Furick cup saddle cast 316 stainless steel. The problem is that you really don't have access to weld the inside. The 2 1/2 mount will fit exhausts from 2.25 to 2.5 in diameter.
Post a Comment for "Marine O2 Sensor Bung"