Skip to content Skip to sidebar Skip to footer

Irritrol Rain Sensor Installation

Irritrol Rain Sensor Installation. Disconnect power to the irrigation system controller. “normally closed” refers to the operation condition of the rain sensor.

Irritrol Rain Sensor install and sync YouTube
Irritrol Rain Sensor install and sync YouTube from www.youtube.com

The orange wire is not used for installation on hunter controllers. Gardenmasters can help you conserve water on your landscaping by installing many of the water saving devices shown below. Rainbird, hunter, irritrol and orbit.

Sales Price $161.55 Our Price $238.95 You Save 32%.


The reliable wireless and wired rain sensors conserve water by preventing irrigation during or after sufficient rainfall, while the wireless rain\/freeze sensor also helps reduce vegetation damage and icing conditions when the temperature drops below a predetermined set point. Suitable for use in residential and commercial systems. Remove the sensor jumper across the two sen terminals in the controller.

Route The Two Wires From The Sensor Into The Cabinet Through The Valve Wire Opening.


Sales price $92.25 our price $128.95 you save 28%. Refer to figure 3, page 7. “normally closed” refers to the operation condition of the rain sensor.

The Reliable Wireless And Wired Rain Sensors Conserve Water By Preventing Irrigation During Or After Sufficient Rainfall, While The Wireless Rain/Freeze Sensor Also


Requires full exposure to sunlight. When installing sensor/transmitter model rfs1000 for freeze detection, refer to additional freeze sensor installation information on page 8. The rainsensor is designed to work with either normally open

Gardenmasters Can Help You Conserve Water On Your Landscaping By Installing Many Of The Water Saving Devices Shown Below.


The first version was manufactured by hardie until the company was purchased by irritrol. Water saving devices available from hunter, toro, irritrol, and rainbird. The sensor senses a rain event and prevents programmed irrigation from happening.

Connect The Sensor Wires To The Terminals In Either Order.


Model rs500, rs1000, or rfs1000. Attach the two yellow wires to the 24 vac terminals. Taking water conservation to the next level, irritrol’s proven rainsensor™ series makes watering in the rain a mistake of the past.

Post a Comment for "Irritrol Rain Sensor Installation"