Onan 5500 Generator Temperature Sensor Location
Onan 5500 Generator Temperature Sensor Location. I think the thermostat housing is attached to the cylinder head on the back side of the engine (the side where the water pump and belt is located). It can run two 13,500 btu ac units with 1100 additional watts available.
I had a secondary line going directly into a gas can with fresh fuel and 2oz of seafoam. This is a 5.5kw rv generator. 47 (controller unable to sense ignition) corrective action:
This Is The Product Manual For A Cummins Onan Rv Qg 5500 Generator.
What i find most interesting is not setting any error codes. 48 (controller unable to sense field voltage) corrective action: Big katuna on 06/29/11 08:07am.
This Onan 5.5 Kw Generator Is Gasoline Powered.
After the generator output voltage builds up, the regulator maintains it nearly constant (within a few volts of 120 vac) under conditions of varying load. Bad reed valve in air injection unit. Generator field sense fault—code no.
View The Cummins Onan Qg 5500 Generator Manual.
Also here is part number if you have one of these generator models, hdkah/j/k/v/tu. The terms of oil temperature sensor and low oil sensor are used on this site, as well as others, who have indicated that mot of the time, when a generator shuts down, it is likely because of this sensor. I disconnected the fuel filter from the pump and added a new one.
47 (Controller Unable To Sense Ignition) Corrective Action:
See an authorized onan dealer. Location mesa, az posts 124 mentioned 0 post(s). Among the causes that lead to the “onan generator starts then shuts down” issue, the sticky switch happen quite frequently.
They Run A Lot Hotter Than 120 Degrees.
Might pick up some ideas from his thread. I think the thermostat housing is attached to the cylinder head on the back side of the engine (the side where the water pump and belt is located). • near an a/c thermostat (one for each zone, 3 maximum)
Post a Comment for "Onan 5500 Generator Temperature Sensor Location"