Hot Tub Temp Sensor Test
Hot Tub Temp Sensor Test. The majority of hot tubs have a sensor that can be found on the internal portion of the filter housing. A simple cause of hot tub overheating is the hot tub’s temperature may be set too high.
Resistance is to be measured between these two terminals with the meter's test leads. The only video out there of a temperature sensor being swapped out on a jacuzzi j 480!my hot tub was hitting the high limit and i just couldn’t get it to coo. So, if the hot tub is set to filter too many hours per day, it can cause overheating.
A Simple Cause Of Hot Tub Overheating Is The Hot Tub’s Temperature May Be Set Too High.
Set the ohm meter to 20,000; Adjust your filter cycle duration cycle down and set it to run early am and late pm, when the outside temperatures are coolest. Find the end of the wires and unplug the board.
You Can Sometimes Recalibrate The Thermostat Using A Tool On The Back Of The Thermostat.
There’s a chance it’s calibrated too high or the circuit may not open when the high temperature is reached. High limit / temperature sensor for balboa m7 systems 32016. Shut off the hot tub’s power at the disconnect panel;
Shut Off All Power To The Spa At The Breaker And Spa Pack.
First, put your hot tub cover back on and let the heater do its job for about 24 hours. Remove the heating element from the circuit. Compare the result to the temperature chart and thermistor resistance chart.
At 77 Degrees It Will Read 10K Ohms.
The cover guy deluxe hot tub cover. In order to test each sensor you must first remove its wires from the sensor harness connector 2. The ohm meter should be on its lowest setting.
To Test A Spa’s Thermostat, First Shut Off All Power To The Hot Tub.
Put the leads of the meter onto the red and green wire. Compare readings to thermistor resistance vs. It is based on a 10k ohm resister.
Post a Comment for "Hot Tub Temp Sensor Test"